Supported cover and cartridge-path rehearsal

DF-GEN-01-TP-02 / DRAFT-1 / DF-GEN-01 / DEMO-01

Inert model/approved training fixture only. Not an OEM operating SOP, service release or competence certificate.

1. Begin with identification

   Complete the configuration/component exercise and state the inert-model boundary.

   HOUSING · Expected: Correct fixture and source revision are identified.

2. Inspect access

   Open the model access-door view. Check the door/fixture relationship visually.

   DOOR · Expected: Door clears the represented support path.

3. Inspect the upper pivot

   Select the upper retaining assembly and observe that its pivot stays on the fixed structure.

   CLIP_UPPER · Expected: The upper assembly is conserved.

4. Inspect the lower pivot

   Select the separate lower assembly; the cover remains seated until both represented states have been reviewed.

   CLIP_LOWER · Expected: Two assemblies remain; housing is fixed.

5. Inspect supported separation

   Move to the axial cover-inspection pose. The support carriage follows the cover.

   COVER · Expected: Cover motion is axial and continuously supported.

6. Inspect the clear position

   View the cover’s supported rightward inspection position.

   COVER_SUPPORT · Expected: The cartridge axis is clear before A moves.

7. Inspect the cradle

   Observe the lowered extension and subsequent raised support pose.

   CRADLE · Expected: Support is in place before A is shown withdrawn.

8. Inspect the same A

   Move toward full inspection spread and follow A along the same axis.

   ELEMENT_A · Expected: The original A stays rigid; B does not move into the housing.

9. Inspect the reverse path

   Return the inspection slider toward assembly: A returns before supports retract and the door closes.

   ELEMENT_A · Expected: The inverse order is visible; no new cartridge appears.

10. Close the exercise record

    Record unclear geometry or evidence for a qualified reviewer. Physical fit and release need their own approved source.

    HOUSING · Expected: Model inspection is not recorded as real equipment readiness.